RFX32 Routing (un)logic

For everything about the EMU sampler EXCEPT preset and cord creations.

Moderators: ezman, stu, Ole

RFX32 Routing (un)logic

Postby bosley » Sat Sep 06, 2003 8:25 pm

I just had a closer look at the rfx-32, which I didn't use that much
until now.
Is it only possible to route signals to the Subout 1, 2, 3...through
a specific Bus...and have only ONE bus to ONE Sub??!

For example I'd like to route a voice to Sub1, perhaps a cabasa from
another voice into Sub3, no Fx on them, but a little reverb
on one clap from the other voice. It doesn't seem possible, is it?

Am I so stupid I didn't understand anything or is the routing that
stupid and unflexible?

thanx 4 your explications
Posts: 10
Joined: Fri Jul 18, 2003 9:41 pm

Return to EOS: The Knowledge